OZONE GENERATORSFOR SPASINSTALLATION & OPERATIONS MANUALFor Models:SpaECLIPSE, CDS-16, ZO-300, ZO-302, & ZO-301MANUFACTURED BYSan Luis Obispo,
8INSTALLATION FOR LOCATION “C”:Turn off the electrical power and drain the spa at least 12 inches below the airventuri line which provides the best su
Turn off the electrical power and completely drain the spa. The DEL RIGIDINJECTOR MANIFOLD must be installed in the spa’s return line after all othere
10Attach the check valve assembly to the ozone generator cartridge. Be surethe check valve bevels are pointed towards the spa and away from theDELZONE
11FAILED DEL SUCTION TESTVery little or no suction may be caused by the list of possible problems below.Review the list then test for suction again.1.
12The spa’s mechanical system will run exactly as before. Note: If the pump isabove the water level of the spa and there is not a flapper valve in the
13Figure 9: SpaECLIPSE/CDS-16 Ozone Chip ReplacementREPLACING THE LAMP CARTRIDGE (ZO-300/302)1. Turn off the electrical power.2. Remove the ozone g
SpaECLIPSE/CDS-16REPLACEMENT PARTS LISTDESCRIPTION PART NUMBERDEL RIGID INJECTOR MANIFOLD (for 2-speed pump) ... IU-201DEL ADJUSTABLE
15TROUBLE SHOOTINGSYMPTOM: No blue light glowing in chip or lamp cartridgePROBABLE CAUSE CORRECTIVE ACTION1. No power to unit 1A. Check power source
Copyright DEL Industries 19995. Too much suction 5A. Adjust the jets to reduce suction6. Dirty, loose, cracked filter 6A. Check/replace filter as ne
DEL Industries • ONE YEAR LIMITED WARRANTYThe limited warranty set forth below applies to products manufactured by DEL INDUSTRIES,3428 Bullock Lane, S
IMPORTANT SAFETY INSTRUCTIONSProper installation and safe use of your DEL spa ozone generator is your re-sponsibility. Read and follow this Owner’s M
TABLE OF CONTENTSImportant Safety Instructions... 1Table of Contents ...
3HOW THE DEL SPA OZONE GENERATOR WORKSOzone is introduced to the spa water through suction created by the spa. Thetubing that is attached to the ozone
4Connecting ZO-300/302: Insert lamp cartridge straight into power supply,being careful to align pins, and bonding plate (on back). Press power supplya
5OZONE SUPPLY TUBING CONNECTION LOCATIONS:OZONE-READY SPASIf your spa is factory equipped with an ozone injection point, follow themanufacturer’s ins
6INSTALLATION FOR LOCATIONS “A” & “B”:Turn off the electrical power and drain the spa at least 12 inches below theselected “A” (Figure 2) or “B” (
7PLASTIC HOSE CONNECTOR INSTALLATION:A plastic hose connector installed onto the air venturi line may be used whenthe spa is not “ozone ready”. The pl
Kommentare zu diesen Handbüchern